1976 Evinrude Water Pump
does anyone know how to take off the foot of an outboard motor?
i think i burnt up my water pump on my 1976 evinrude outboard and cant get the foot off
what horsepower?
I’ll assume it’s a 3-cylinder or better.
1. disconnect shift linkage under the bottom carb.
2. remove the trim tab (scribe a mark across the edge so you can get it back like it was).
3. remove the retaining bolt from the trim tab cavity.
4. remove the other retaining bolt from the bottom side of the antiventilation plate.
5. remove the four retaining bolts from the perimeter, just above the antiventilation plate.
pull the lower unit off.
The shift rod height is adjusted by screwing it in or out, so don’t twist it or else it won’t fit when you put it back.
on reassembly:
1. put molly lube on the drive shaft splines (but not on top, there’s not enough clearance).
2. the rubber o-ring just below the drive shaft splines — you need that.
3. put omc gasket sealant (or some kind of anti-sieze) on the retaining bolts — or else corrosion will set in & it’ll be a bitch next time.
4. use 3m #847 or permatex #2 on the joint between midsection & lower unit.
Replace the impeller every two-three years as preventive maintenance.
|
|
OMC Johnson Evinrude water pump repair kit new NOS 389164 1973-1976 115hp 135hp $84.99 |
|
|
WATER PUMP EVINRUDE JOHNSON 65 70 75 1974 1975 1976 1977 1978 $69.95 |